[ale] Boot failed

Jerry Yu jjj863 at gmail.com
Mon Feb 13 10:09:26 EST 2006


I went through similar confusions a few weeks back. I had a SATA drive all
by itself (sda) and a IDE drive (hda) on primary master. I ran grub-install
against both sda and hda with two different grub.conf, since who's hd0
depends on which device grub-install is running against, use '-recheck'
first to be sure.
When I have grub on only one of them (can't recall which exactly now), I
will get 'boot fail, press enter to continue'. It find grub on the 2nd drive
once I press 'enter'. I guess it'd be simply 'boot fail' if your BIOS is not
tolerant or informed enough to seek more boot devices among hard disk group.

On 2/11/06, Paul Cartwright <paul_tbot at pcartwright.com> wrote:
>
> On Sat February 11 2006 6:04 am, aaron wrote:
> > Serial ATA (SATA) chipsets -- Linux support status
> >
> > Revised: Wed Jan 11 18:25:55 PST 2006
>
> a wealth of information, thanks!!!
>
> unfortunately the application I am installing requires RHES 3 update
> 4..
> but at least now I know!
>
> --
> Paul Cartwright
> Registered Linux user # 367800
> _______________________________________________
> Ale mailing list
> Ale at ale.org
> http://www.ale.org/mailman/listinfo/ale
>
-------------- next part --------------
An HTML attachment was scrubbed...




More information about the Ale mailing list