[ale] Voodoo 3 3000 & Glide?

[Dave Brooks]

Welp, Santa treated me well to a Voodoo3 3000.

However, I'm experiencing a little difficulty getting this thing to work
correctly.  Here's what I've done thus far:

o I've rebuilt the entire XFree86-3.3.5.src.rpm into a binary RPM for
	my system and installed it;
o I've configured X to use the SVGA server;
o I've rebuilt the Device3Dfx-2.3-3.src.rpm into a binary RPM for my
	system and installed it;
o I installed the Glide2x package (also tried the Glide3x package, but not
	concurrently, obviously)

When I try and run the glide test (/usr/local/glide/bin/test3Dfx), it says to
"press any key to begin test"; and when I do that it reports this error:

--- snip snip ---

gd error (glide): Can't find or access Banshee/V3 board
gd error (glide): grSstSelect:  non-existent SST
zsh: segmentation fault  ./test3Dfx

--- snip snip ---

I've tried installing the Glide3x package, both seperately and by --force'ing the
installation of the RPM over the Glide2x, etc.  Am I missing a step, here?  Should
I be looking for anything else?  On linux.3dfx.com, it said that when I run XF86Setup,
I should configure both the 2D resolutions I want X to run at and the 3D screeen
resolutions.  I didn't see an option for the 3D aspect.  Did I overlook something?

Thanks, and Regards,
Dave Brooks

-- 
david a. brooks
dbrooks at comstar.net
systems engineer
comstar.net, inc.
voice: .. 770/485-6029
pager: .. 770/213-6133
--
To unsubscribe: mail majordomo at ale.org with "unsubscribe ale" in message body.