[ale] Set MAC address on bootup

Mike Millson mgm at atsga.com
Wed Jan 16 07:28:00 EST 2002


I have bridged DSL from BS, and I replaced my linksys router a few months
ago. This is the DSL that edits the MAC address before it gives out an IP
address. So, every time I boot up, I bring down my NIC (ifconfig eth0 down),
then assign it the MAC address of my old linksys router (ifconfig eth0 hw
ether MAC_ADDRESS), then bring up the NIC (ifconfig eth0 up), then go into
control panel (control-panel) and activate eth0 to get my IP address from
BellSouth.

Is there any way to automate assigning this new MAC address at startup so I
don't have to do any manual config when I reboot?

Thank you,
Mike Millson
----------------------------------------
AableTech Solutions, Inc.
770.414.8834
770.414.8206 fax
http://www.atsga.com
----------------------------------------



---
This message has been sent through the ALE general discussion list.
See http://www.ale.org/mailing-lists.shtml for more info. Problems should be 
sent to listmaster at ale dot org.






More information about the Ale mailing list