[ale] Linux and two ethernet cards

[ari]

add

  append = "ether=12,0x300,eth0 ether=15,0x340,eth1"

or something similar to /etc/lilo.conf before any image entries, and run lilo.
reboot, and all should theoretically be recognized properly.

the order's like this:
ether=<irq>,<base address>,<device>

you can add more to the setup, but that seems to usually be enough.

ari


Adam Teja (arteja at yahoo.com) said this stuff:

> Hello,
> 
> I'm trying to install two ethernet cards, 3C905 (Boomerang PCI) NICs,
> on Redhat Linux 4.2...
> 
> Linux sees both cards at boot time, but assigns both cards the same
> Base I/O address (different Interupts) 
> does anyone know how I can load these two cards (and get Linux to see
> both cards)
> 
> I'm trying to share a cable modem between several PC's
> 
> I've tried the ethernet how-to, but it wasn't uch help.
> 
> Thanks,
> Adam