[ale] meaning of messages reported by setserial?

[Unix Guru Dude]

}I just noticed that on bootup I am getting the following messages:
}
}Configuring serial ports..../dev/cua2, Line 2, UART: 16550A, Port: 0x03e8, IRQ: 3
}        Baud_base: 115200, close_delay: 50, divisor: 0
}        Flags: spd_hi skip_test

man setserial:

       close_delay delay
	      Specify the amount of time, in hundredths of a sec-
	      ond,  that  DTR  should remain low on a serial line
	      after the callout	 device	 is  closed,  before  the
	      blocked	dialin	device	raises	DTR  again.   The
	      default value of this option  is	50,  or	 a  half-
	      second delay.

Kinda makes sense...

}
}Does anyone know what the "close delay: 50" and "divisor: 0" mean?

       divisor divisor
	      This option sets the custom divison.  This  divisor
	      will  be	used when the spd_cust option is selected
	      and the serial port is set to 38.4kb by the  appli-
	      cation.	This parameter may be specified by a non-
	      privileged user.

       spd_cust
	      Use the custom divisor to set the	 speed	when  the
	      application  requests  38.4kb.   In  this case, the
	      baud rate is the baud_base divided by the	 divisor.
	      This parameter may be specified by a non-privileged
	      user.
       
}I am invoking this from rc.serial with the following lines:
}
}/bin/setserial /dev/cua2 uart 16550A port 0x3e8 irq 3 spd_hi
}/bin/setserial -a /dev/cua2
}
}and port cua2 is my 14.4 USR Sportster modem.
}-- 
}Steven A. DuChene       Linux Weenie!    http://www.ysu.edu/~sduchene
}
}Those who are mentally and emotionally healthy are those who have
}learned when to say yes, when to say no and when to say whoopee.
}                -- W.S. Krabill

-- 
Until later:
Geoffrey Myers   geof at denali.is.net   eiger at ichange.com   gamyers at attmail.com
	http://www.ticllc.net/~geof

	Opinions expressed by me are mine, all mine, only mine.....